After printing, the printing should be done. If the temperature of the developer in the plate processor is too low, the processing speed of the plate processor is too fast, the development time will be shortened, the development will be insufficient, and the printing plate will not be cleaned. If the concentration of the developer is insufficient, the time for replenishing the developer is adjusted too long, and the printing plate will be insufficiently developed. The method to eliminate the above failure is to check the temperature and development time of the developer, and adjust to reasonable data. When using the developer, the manufacturer will provide the ratio of the formula, which should be done according to the ratio. But sometimes it can be more concentrated. The plate processor should be repaired in time, replace the rubber roller, and regularly clean the crystals in the tank and on the wall of the tube. The specific method is: use oxalic acid to circulate the water in the processor and effectively remove the dirt. At the same time, the brush roller on the machine should also be cleaned and replaced if necessary. In addition, in the process of decontamination, the operation is not careful, the amount of decontamination solution is insufficient, the use time is short, the decontamination note is invalid, and the dryness of the decontamination solution on the plate surface may cause the plate to be dirty. During the gluing process, low concentration glue is used, and oxidation of non-graphic parts will cause the printing plate to become dirty. The solution to this kind of problem is: after decontamination, the cover should be tightly closed; after the plate is decontaminated, it should be fully washed, the glue concentration should be increased when glue is applied, and the glue injection should be uniform; After printing. Macaron Silicone Baking Mat,Silicone Rolling Baking Mat,Baking Pastry Mat,Silicone Baking Mats Changshu Xinneng Silicone Products Co., Ltd. , https://www.xnsilicone.com