Some Luya beginners found that the Luhe wheel wasn't a normal cylindrical shape after installation. Instead, it was either orthodox or inverted, causing the line to reach the desired length. This situation is common in the use of spare thread cups in newly purchased spinning wheels or two-wire cup spinning wheels, and it is considered that the quality of your Luer round is not good.
In fact, the wheel of the spinning wheel at the time of assembly is also required to be adjusted so that the wrapped wire is in the best shape to achieve the maximum amount of wire. In many cases, the poor line morphology is not a result of the poor quality of the Luer's wheel, but rather caused by the completion of work during the factory adjustment. This situation is common in domestically produced spinning wheels. Here's specific to tell you about the line cup adjustment method Lu Ya wheel assembly line:
1. First, try to wrap around a few turns at the beginning of the winding and observe whether the number of turns on the line cup is evenly distributed. If you feel that the number of turns is not easy to observe, increase the number of turns. If the two ends of the more uniform coil can be aligned to the edge of the line cup pool, no adjustment is needed. If you find that the number of laps above and below the lap count is significantly different, you should make adjustments.
2. Remove the thread cup when adjusting. Unscrew the drag button on the line cup to take off the line cup, as shown in the figure, from left to right: Spindle body assembly, crash pad (to prevent spindle wear), adjust the gasket, adjust Gaskets 2, ratchet teeth, line cups; one of the next two is the spare line cup and drag button.
Precautions
The principle of adjustment is that the shape of the winding line of the wire cup is a forward taper, that is, the number of coils below the wire cup is greater than the number of the coils at one end of the drag button. It is necessary to reduce the adjustment of the gasket; the line cup shape is inverted taper, increase the adjustment gasket. After the adjustment, install the test winding to observe whether it meets the requirements. It should be noted that the thickness of the two adjustment pads should not be the same. Subtle adjustments can be made according to actual needs until ideal.
Wall Hangings
A beautiful handmade macrame wall hanging made with 100% natural cotton cord , These knitted wall hangings can decor your wall and make your home cozier , you can hang textile wall hangings above the sofa , fireplace , desk , or on the top of the bed , wall hangings fabric will add instant texture and charm to any space in your home .
Wall Hangings,Wall Hanging Macrame,Wall Hanging Art,Wall Hanging Macrame Plant Holder
Shandong Guyi Crafts Co.,Ltd , https://www.guyicraft.com