[ Chinese wardrobe net ] The cloakroom belongs to the cabinet category. The cabinet is an important part of the bedroom furniture, and it is also one of the large parts of the bedroom furniture. Therefore, the quality of the cabinet directly affects the sales of the whole product. According to incomplete statistics, the most dissatisfied consumers are the warping deformation of the cabinet door. “Actually, in addition to materials and design reasons, the influence of unfavorable factors in the processing process is the main reason for the bending deformation of the long door of the high cabinet. How can we prevent the aging process of the cloakroom while decorating the home? 1, wooden wardrobe , usually just wipe with a clean rag, but if there is dirt, you can use soap or neutral detergent, wipe with a damp cloth. 2, if you want to wax, it is best to choose a higher concentration of solid, silicone-free wax, so as not to damage the paint surface. 3, improper coating treatment, resulting in deformation of panel furniture components. 4. Ultraviolet rays are also destructive to wood furniture. Therefore, it is necessary to use cloth or curtains to avoid sun exposure. 5. Avoid using irritating and corrosive chemicals such as alcohol and detergents that are easily damaged by wood. 6. The influence of the drying process In the production of many manufacturers, when the board is coated with putty or paint, it should be placed on the drying rack for natural drying. If the rod of the drying rack is too sparse or uneven, it will also cause The cloakroom door component is found to be bent and deformed during the drying of the paint. The influence of the internal stress of the coating will form a certain coating after curing. Even if there is no external force, an internal stress will be generated. If the internal stress is not handled properly, it will become the main cause of bending deformation of the door part of the cloakroom. one. 7. Deformation caused by stacking of parts In the production, some operators are convenient for drawing, stacking the plates freely, or stacking the plates is not flat, and even leaning the plates against the wall, causing the plates It deformed due to its own weight before entering the next process. The coating process causes deformation During the finishing process, due to improper use of the process and raw materials, the plate is deformed and deformed as the internal stress of the coating changes. 8. The effect of finishing putty When decorating the door parts, many manufacturers use pig blood putty or glue to prepare putty in order to reduce the cost. Because these two kinds of putty contain a lot of water, the commonly used substrate of plate furniture - Medium-density fiberboard and particleboard are particularly hygroscopic, so when one side of the door panel component is not putty, and the other side is coated with such a water-rich putty, the door panel component is hygroscopic and deformed. Door Drapes,Bedroom Door Curtains,Macrame Door Curtain,Macrame Cotton Door Curtain Shandong Guyi Crafts Co.,Ltd , https://www.sddoorcurtains.com