On the afternoon of December 3, a man in Jiangsu Tongda Paper was involved in the operation of the equipment and his arm was caught in the machine. Fortunately, the firefighters arrived in time. After 20 minutes, the worker was successfully rescued and sent to the hospital for treatment. Accident scene At 4 o'clock in the afternoon of December 3, an accident occurred in Tongda Paper Industry, Fenghuang Industrial Park, Yanling Town, Danyang. The right hand of a middle-aged male staff member was involved in the machine. After receiving the alarm, the Yunyang Fire Squadron in the jurisdiction was in charge of the fire. People rushed to the scene to dispose of. When the firefighters arrived, the man in the overalls, his right hand was caught in the composite wheel of the paper cutting machine, and the sleeves were torn off. The firefighters immediately cut off the lower composite wheel by using a shear expander in conjunction with the factory's plasma cutting machine. After about 20 minutes, the male workers were relieved and immediately taken to the hospital for treatment. It is understood that the man did not close the shutdown device in time during the production process, which inadvertently involved the right hand. How to avoid injury accidents during production First of all, the operation of various mechanical personnel must undergo professional training, can master the basic knowledge of the performance of the equipment, passed the examination, and hold the certificate. In the on-the-job operation, it must be carefully operated, strictly enforce the relevant rules and regulations, use labor protection articles correctly, and prohibit unlicensed personnel from starting mechanical equipment. Secondly, the wires for power supply must be properly installed and there must be no damage or leakage. The motor insulation should be good and the terminal block should be protected by a cover. Switches, buttons, etc. should be intact, and the live parts must not be left naked. Before the operation, the mechanical equipment should be inspected for safety. First, the vehicle is running, and after confirming the normal operation, it is put into use. When the mechanical equipment is in operation, it is strictly forbidden to adjust by hand; the parts should not be measured by hand or be lubricated or cleaned. When the mechanical equipment is running, the operator must not leave the job. It should be noted that the switch should be turned off immediately after the work is over. Safety production must not be relaxed at all times to prevent injury accidents. This article is posted on the website for the purpose of transmitting more information and does not imply endorsement of its views or confirmation of its description. Article source address: http:// Silicone Cup,Silipint Cups,Sili Cups,Silicone Travel Mug MeMe Baby Product (GZ) LLC , https://www.gzkupbo.com