Customers in the automotive tire grinding industry order a car tire grinding oven from our company and cooperate with them! In this case, I will introduce you to the car tire mold oven produced by our company. Customer requirements are as follows: Technical Parameters: The physical map effect is presented:
Non-Stick Oven Liner has a superior Non-stick surface, could resist heat up to 500F, and is dishwasher safe.
By using this mat, the oven would never need to clean, and this liner is also very easy to clean, simply wash it with warm soapy water would be enough.
This Oven Liner is FDA & LFGB & CA65 Certificated, and our factory is BSCI Audited.
Non-Stick Oven Liner & Baking Liner Non-Stick Oven Liner,Non-Stick Baking Liner,Oven Mat Liner,Oven Bottom Liner Jiangsu Esone New Material Co,.Ltd , https://www.cookware-manufacturer.com
Standard sizes:
Internal dimensions: D1500mm × W1500mm × H2000mm (effective use of space calculation)
External dimensions: D1720mm × W2300mm × H2410mm (maximum size calculation)
1. Air supply mode: forced air circulation
2. Heating rate: normal temperature +40 ~ Max300 ° C, 250 ° C time required about 55-60 minutes (empty box test)
3. Maximum temperature: 300 °C
4. Uniform performance: Temperature tolerance is ±2.5°C when tested at 250 °C (empty box test)
5. Insulation performance: 250 ° C in the furnace, the outer wall temperature does not exceed 45 ° C (room temperature +5 ° C
6. Air duct design: It adopts the combination of the side air duct and the top air duct cycle. The double door is opened, the door buckle is fixed by the tie rod, the foaming high temperature silicone sealing strip is sealed, and the different air deflectors are installed and installed on the air ducts on both sides to make the hot air circulation side The air volume can be controlled to achieve a more uniform temperature inside the box.
7. Baking structure: The inner chassis of the oven is equipped with a solid aluminum disc with a diameter of 1300mm and a thickness of 22mm. It can carry more than 800kg. It is supported by a shaft with a diameter of 80mm. The transmission power is 0.75KW. Inside the electrical box, the chain drives.
HUMGINE products: automobile tire mold oven, high and low temperature test chamber, high and low temperature alternating heat and humidity test chamber, high and low temperature alternating test chamber, environmental test chamber, high temperature test chamber, HMDS vacuum oven, clean oven, clean oven, 